Portaal Portaal Pingviini veeb foorumi pealeht
  Viki  |  IRC  |  Otsing  |  Küsimused ja vastused  |  Profiil  |  Privaatsõnumite vaatamiseks logi sisse  | Logi sisse või Registreeru
<empty>
Vaata järgmist teemat
Vaata eelmist teemat

Postita uus teemaVasta teemale
Autor Sõnum
kessu
Vana Pingviin
Vana Pingviin


Vanus: 44
Liitunud: 16.07.2007
Postitused: 1106

Distributsioon: Ubuntu 16.04 LTS 64bit
estonia.gif
postituspostitatud: 16.10.2010, 22:52  postituse pealkiri:  Kirjutamise probleem (K3b ja brasero)  

Brasero keeldub üldse töötamast, aga K3b annab veateate:
Kood:
Devices
-----------------------
HL-DT-ST DVD-RAM GH22NP20 1.04 (/dev/sr0, CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD-R DL, DVD+R, DVD+RW, DVD+R DL) [DVD-ROM, DVD-R Sequential, DVD-R Dual Layer Sequential, DVD-R Dual Layer Jump, DVD-RAM, DVD-RW Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, DVD+R Dual Layer, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R, Restricted Overwrite, Layer Jump] [%7]

System
-----------------------
K3b Version: 1.91.0
KDE Version: 4.4.2 (KDE 4.4.2)
QT Version:  4.6.2
Kernel:      2.6.32-25-generic

Used versions
-----------------------
cdrecord: 1.1.10

cdrecord
-----------------------
scsidev: '/dev/sr0'
devname: '/dev/sr0'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.10
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
TOC Type: 1 = CD-ROM
Driveropts: 'burnfree'
Device type    : Removable CD-ROM
Version        : 5
Response Format: 2
Capabilities   :
Vendor_info    : 'HL-DT-ST'
Identification : 'DVD-RAM GH22NP20'
Revision       : '1.04'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0011 (DVD-R sequential recording)
Profile: 0x0012 (DVD-RAM)
Profile: 0x002B (DVD+R/DL)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0016 (DVD-R/DL layer jump recording)
Profile: 0x0015 (DVD-R/DL sequential recording)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0011 (DVD-R sequential recording) (current)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW)
Profile: 0x0009 (CD-R)
Profile: 0x0008 (CD-ROM)
Profile: 0x0002 (Removable disk)
Using generic SCSI-3/mmc DVD-R(W) driver (mmc_mdvd).
Driver flags   : SWABAUDIO BURNFREE
Supported modes: PACKET SAO
Drive buf size : 1409024 = 1376 KB
FIFO size      : 12582912 = 12288 KB
Speed set to 5540 KB/s
Track 01: data  2940 MB       
Total size:     3377 MB (334:36.80) = 1505760 sectors
Lout start:     3377 MB (334:38/60) = 1505760 sectors
Current Secsize: 2048
HINT: use dvd+rw-mediainfo from dvd+rw-tools for information extraction.
Blocks total: 2298496 Blocks current: 2298496 Blocks remaining: 792736
Starting to write CD/DVD at speed   4.0 in real SAO mode for single session.
Last chance to quit, starting real write in    2 seconds.
   1 seconds.
   0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Sending CUE sheet...
Starting new track at sector: 0
Track 01:    0 of 2940 MB written.
Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error
CDB:  2A 00 00 00 00 00 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 00 00 0C 80 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x0C Qual 0x80 (write error) [No matching qualifier] Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 2.087s timeout 200s
/usr/bin/wodim: A write error occured.
/usr/bin/wodim: Please properly read the error message above.
write track data: error after 0 bytes
Writing  time:   11.139s
Average write speed 111.0x.
Fixating...
Fixating time:    0.003s
/usr/bin/wodim: fifo had 191 ******** and 1 gets.
/usr/bin/wodim: fifo was 0 times empty and 0 times full, min fill was 100%.

cdrecord command:
-----------------------
/usr/bin/wodim -v gracetime=2 dev=/dev/sr0 speed=4 -sao driveropts=burnfree -data -tsize=1505760s -

Niisiis, milles viga? Ei saa üldsegi kirjutada.

_________________
Olen umbkeelne mulk ja ei saa võõrastest keeltest piisavalt aru

sander85
Vana Pingviin
Vana Pingviin


Vanus: 34
Liitunud: 08.08.2005
Postitused: 4358
Asukoht: Tallinn (vahel ka Virtsu)
Distributsioon: Mageia, Debian, CentOS
estonia.gif
postituspostitatud: 17.10.2010, 16:56  postituse pealkiri:  (teema puudub)  

väidab meediumi viga, et siis kasutatav toorik saast?

_________________
Image Image Image

kessu
Vana Pingviin
Vana Pingviin


Vanus: 44
Liitunud: 16.07.2007
Postitused: 1106

Distributsioon: Ubuntu 16.04 LTS 64bit
estonia.gif
postituspostitatud: 18.10.2010, 08:13  postituse pealkiri:  (teema puudub)  

Soo ...

_________________
Olen umbkeelne mulk ja ei saa võõrastest keeltest piisavalt aru

Näita (aja järgi):      
Postita uus teemaVasta teemale


Vaata järgmist teemat
Vaata eelmist teemat
Powered by phpBB2 Plus based on phpBB © 2001/7 phpBB Group