Pingviini veeb

Kood: Vali kõik

$ cat /etc/fstab
/dev/sda1        /                reiserfs    defaults         1   1
/dev/sda2        /home            reiserfs    defaults         1   2
/dev/sda3        /mnt/data1       reiserfs    defaults         1   2
/dev/sdb1        /mnt/data2       reiserfs    defaults         1   2
/dev/sdb2        /mnt/data3       reiserfs    defaults         1   2
/dev/hda5        /mnt/travel1     ext2        defaults         1   2
/dev/hda6        /mnt/travel2     ext2        defaults         1   2
/dev/cdrom       /mnt/cdrom       iso9660     noauto,owner,ro  0   0
/dev/fd0         /mnt/floppy      auto        noauto,owner     0   0
devpts           /dev/pts         devpts      gid=5,mode=620   0   0
proc             /proc            proc        defaults         0   0
$

Kood: Vali kõik

# cdrecord --scanbus
Cdrecord-Clone 2.01 (i686-pc-linux-gnu) Copyright (C) 1995-2004 Jörg Schilling
Linux sg driver version: 3.1.25
Using libscg version 'schily-0.8'.
scsibus0:
        0,0,0     0) 'ATA     ' 'ST380817AS      ' '3.42' Disk
        0,1,0     1) *
        0,2,0     2) *
        0,3,0     3) *
        0,4,0     4) *
        0,5,0     5) *
        0,6,0     6) *
        0,7,0     7) *
scsibus1:
        1,0,0   100) 'ATA     ' 'ST380817AS      ' '3.42' Disk
        1,1,0   101) *
        1,2,0   102) *
        1,3,0   103) *
        1,4,0   104) *
        1,5,0   105) *
        1,6,0   106) *
        1,7,0   107) *
scsibus2:
        2,0,0   200) 'PLEXTOR ' 'CD-R   PREMIUM  ' '1.05' Removable CD-ROM
        2,1,0   201) *
        2,2,0   202) *
        2,3,0   203) *
        2,4,0   204) *
        2,5,0   205) *
        2,6,0   206) *
        2,7,0   207) *
#

Kood: Vali kõik

# mount /mnt/cdrom/
mount: special device /dev/cdrom does not exist
#

Kood: Vali kõik

# cdrecord dev=2,0 blank=fast
Cdrecord-Clone 2.01 (i686-pc-linux-gnu) Copyright (C) 1995-2004 Jörg Schilling
scsidev: '2,0'
scsibus: 0 target: 2 lun: 0
Linux sg driver version: 3.1.25
cdrecord: No such file or directory. Cannot open '/dev/sg*'. Cannot open SCSI driver.
cdrecord: For possible targets try 'cdrecord -scanbus'.
cdrecord: For possible transport specifiers try 'cdrecord dev=help'.
#

Kood: Vali kõik

# Start LILO global section
append="hdc=ide-scsi"
boot = /dev/sda

Kood: Vali kõik

# mount /dev/hdb /mnt/cdrom/
mount: /dev/hdb is not a valid block device
#

Kood: Vali kõik

# mount /dev/cdrom
mount: special device /dev/cdrom does not exist
# mount /dev/hdb /mnt/cdrom/
mount: /dev/hdb is not a valid block device
# mount /dev/hdc /mnt/cdrom/
mount: you must specify the filesystem type
# mount -t iso9660 /dev/hdc /mnt/cdrom/
mount: wrong fs type, bad option, bad superblock on /dev/hdc,
       missing codepage or other error
       (could this be the IDE device where you in fact use
       ide-scsi so that sr0 or sda or so is needed?)
       In some cases useful info is found in syslog - try
       dmesg | tail  or so

# mount -t iso9660 /dev/sr0 /mnt/cdrom/
mount: block device /dev/sr0 is write-protected, mounting read-only
#

Kood: Vali kõik

/dev/sr0         /mnt/cdrom       iso9660     noauto,owner,ro  0   0

Kood: Vali kõik

#mkdir /mnt/usb
#chmod -R a+rwx /mnt/usb
# dmesg | tail
scsi3 : SCSI emulation for USB Mass Storage devices
  Vendor: I-Stick2  Model: IntelligentStick  Rev: 2.00
  Type:   Direct-Access                      ANSI SCSI revision: 02
Attached scsi removable disk sdc at scsi3, channel 0, id 0, lun 0
SCSI device sdc: 255488 512-byte hdwr sectors (131 MB)
sdc: Write Protect is off
 sdc: sdc1 sdc2 sdc4
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
# mount -t vfat /dev/sdc /mnt/usb/
# bingo
bash: bingo: command not found
# umount /mnt/usb/
#

Kood: Vali kõik

/dev/sdc         /mnt/usb         vfat        noauto,owner     0   0